Your questions
Our answers
The most likely answer is that the shock absorbers have been worn or damaged. If working correctly, the shock absorbers would stop any excessive leaning or dipping. While a certain amount of body roll is normal in any car, if you have specifically noticed a change in the way your car is handling, you should always bring your car in for a technician to take a look.
Without your entire suspension system in good working order, your car is likely to be less efficient and more importantly, your safety could be at risk.
Xenon lights are a relatively new development in modern cars. They emit light that’s closer to daylight than halogen lights. This also means they are much more powerful and last much longer than traditional lights.
When they do need replacing, xenon lights use a particular type of bulb. These contain xenon gas, drawing 20,000 volts (compared to 12 volts for a traditional bulb).
One of our technicians will be able to help you replace your xenon bulbs.
Drum brakes use pads and shoes inside a casing (the drum) to slow your vehicle down. The pads are pushed outwards, causing friction. Disc brakes on the other hand are arranged differently; a disc mounted to the wheel is gripped on both sides by brakes pads. Again this causes friction and slos the vehicle down.
Disc brakes generally provide more braking power and most cars will have these mounted at the front of the vehicle. Some will still have drum brakes mounted at the back, which are required to do less braking.
Both types of braking system use the same principal of applying friction in order to slow down your vehicle, so both will wear out over time.
There could be a problem with the catalytic converter or the lambda sensor. The lambda sensor is located in the exhaust system and allows the engine to control the ratio of air and fuel. When this sensor is damaged, the signal to the engine fails. This sends the vehicle into a limp mode, which generally prevents the vehicle from going over 40 mph.
If the catalytic converter is damaged on the other hand, harmful gases are not transformed correctly. Again, a signal is sent to the engine, switching it to limp mode.
In either case, call your local Eurorepar Car Service Centre who will be able to diagnose the issue and suggest a solution.
An MOT test generally takes 45-60 minutes to complete. Some Eurorepar Car Service Centres offer waiting appointments; if you plan to wait with us while we carry out the MOT test, just let us know. We’ll do our best to keep you updated with the progress of your vehicle.
Your questions
The most likely answer is that the shock absorbers have been worn or damaged. If working correctly, the shock absorbers would stop any excessive leaning or dipping. While a certain amount of body roll is normal in any car, if you have specifically noticed a change in the way your car is handling, you should always bring your car in for a technician to take a look.
Without your entire suspension system in good working order, your car is likely to be less efficient and more importantly, your safety could be at risk.
Xenon lights are a relatively new development in modern cars. They emit light that’s closer to daylight than halogen lights. This also means they are much more powerful and last much longer than traditional lights.
When they do need replacing, xenon lights use a particular type of bulb. These contain xenon gas, drawing 20,000 volts (compared to 12 volts for a traditional bulb).
One of our technicians will be able to help you replace your xenon bulbs.
Drum brakes use pads and shoes inside a casing (the drum) to slow your vehicle down. The pads are pushed outwards, causing friction. Disc brakes on the other hand are arranged differently; a disc mounted to the wheel is gripped on both sides by brakes pads. Again this causes friction and slos the vehicle down.
Disc brakes generally provide more braking power and most cars will have these mounted at the front of the vehicle. Some will still have drum brakes mounted at the back, which are required to do less braking.
Both types of braking system use the same principal of applying friction in order to slow down your vehicle, so both will wear out over time.
There could be a problem with the catalytic converter or the lambda sensor. The lambda sensor is located in the exhaust system and allows the engine to control the ratio of air and fuel. When this sensor is damaged, the signal to the engine fails. This sends the vehicle into a limp mode, which generally prevents the vehicle from going over 40 mph.
If the catalytic converter is damaged on the other hand, harmful gases are not transformed correctly. Again, a signal is sent to the engine, switching it to limp mode.
In either case, call your local Eurorepar Car Service Centre who will be able to diagnose the issue and suggest a solution.
An MOT test generally takes 45-60 minutes to complete. Some Eurorepar Car Service Centres offer waiting appointments; if you plan to wait with us while we carry out the MOT test, just let us know. We’ll do our best to keep you updated with the progress of your vehicle.